Water Jetting Association Members

HYDROPUMPS LTD

Member Type: C1 - Water Jetting Contractor
Categories: Contractor - High Pressure, Cutting & Breaking, Hydrodemolition, Surface Preparation - UHP
Address:

19 Highmead
Fareham
Hants
PO15 6BL

Tel: 01329823420
Fax: 01329823425
Web: www.hydro-pumps.co.uk
Email: Send message

Hydropumps Ltd
Our company has over 75 years experience in the field of controlled demolition and reconstruction. Specialising in the fields of “Hydro-demolition, Diamond Wire and Saw Cutting, Wet Abrasive Cold Cutting, Surface Preparation/Cleaning, Sprayed Concrete both dry and wet methods, Concrete Repairs, high flow concrete, Grouting and Coating application”.

We offer assistance in all project stages from the planning and design, to final completion, express strong emphasis on partnership with the client.

Our aim is to give an efficient service based on a mutually agreed program, and will at all times proffer assistance with problem solving based on our broad practical knowledge.

Being constantly on the look out for breakthroughs in technique and equipment we can offer the most up-to-date service available, with members of the management sitting on various industry associations.

Our company is equipped with its own up to date fleet of specialist equipment, Maintained and tested at our plant yard in Stourport-on-Severn, West Midlands were we also offer training in the use of specialist equipment to both our own operatives and third parties.

Our operatives are encouraged to present a positive attitude, with full backing the management team.

The company is divided into four sections:

“HYDRO-DEM – DIAMOND CUTTING – CONCRETE REPAIRS – PUMP INSTALLATION – SALES MAINTENANCE AND TRAINING”.

Services we provide:

Hydro Demolition.
Cold abrasive cutting.
Surface preparation.
Concrete repairs including spray applied concrete.
Diamond cutting and drilling.
Percussive Drilling (Hand, Hands Free and Small mobile mast)
Consultation and advice on contract design.
Pump and ancillary supply, installation and servicing.
Training in safe operation of high pressure equipment to WJA standards.
We can offer any or a combination of “all the above operations” to carry out part of, or a complete stand alone contract, under our or your supervision.

Robotic Cutting:

Used on larger contracts, particularly useful for deck and repetitive work. Robotic units do require the use of hand lance units to trim following bulk removal. Both robots are computer controlled. Once the operative has programmed the relative cut parameters into the unit, it will travel across the structure at the set rate with the required number of lance paces.
The cutting lance moves from side to side along a rack contained within a debris box, however secondary protection may be required in high risk areas to contain any chips escaping from under the base seal.
This may be by the use of a large tarpaulin sheet stretched over the cutting head dragged along by the unit (good for deck work), or the construction of a debris netting tunnel.

Cutting of structure using 750 H.P.1150 bar 238 lt per min pump connected to Conjet 362 MPA robot fitted with a multi- purpose arm. A debris-netting cage has been used to arrest any flying concrete, as works is directly adjacent to and over live traffic.

Conjet 322 Tracked robot fitted with 360 degree arm. Connected to two number 1500 bar @ 56 lt per min units giving working flow and pressure of 112 lt at 1500 bar.